A demonstration of my UnderWare technique for BrickFa figures.
About this creation
Here is a fairly basic BrickFa figure. BrickFa is really great, except for the large hole where a pelvis should be. I've created (I think) a technique for filling that gap. I call it "UnderWare". ;)
Here are the pieces you'll need. Make the colors match the color of the hip joints you're using. I didn't do that here, but I should have.
Here's the UnderWare put together. You need the hook to attach vertically like the picture shows to get it into place on the figure.
Slide the UnderWare into position between the legs, with the handle and hands on the front.
Now you need to twist the hook piece 90 degrees so that it can swing up and down. Use the hook piece to clamp the UnderWare in place.
Swing the hands down so that they form the underwear shape and you're done! If it isn't sturdy and wobbles around, adjust the hook on the back. Make sure it's clamping onto the torso and not the hip joints.
UnderWare leaves a spot on the rear that could be used in various ways. Put a tail or something on it! The hook piece also allows the figure to sit without falling over backwards.