Custom General Grievous: A LEGO® creation by BeanFlea 12 : MOCpages.com

Custom General Grievous

Rated 5 out of 5 Change your rating

Zoom in

This is my Lego Custom General Grievous, which I decided to make after being inspired by a few designs I had seen. After trying and failing to copy someone else's I decided to make my own, which I think turned out really well, althought I did have to cut a few bits up in the process. Comment and rate please!

About this creation

Side on view.

Back view.

Without the cape. Have a look at the shoulders, I like the way I managed to give him broad shoulders just like when he is hunched over with his cape =)Also notice him feet, they are minifigure hands with a small clip on the back to make them look more claw-like. However, this does mean he doesn't stad up unaided unless you have very good balance =) I use blutac to stand him up =)

Back view without the cape. The hardest part was attaching the arms to the main bar that hols his legs together. I had to glue a few things together in the end.

With another figure for size comparison. I think I just about got the scaling right as if Grievous is straightening his back out - OK, maybes just a little too tall =)

With his lightsabers =)

Close up of the chest. I actually used the official Lego General Grievous body for this as I think it looks OK, but the arm joints are too restricted.

Comments

Add a comment

I like it

S.A III

December 29, 2009

Nice Grievous, and, no I don't think he looks too tall in the size comparison! BTW, I think I have a solution to the cape problem.... Maybe velvet would work?