A lot of people like my "Support Gunner" mini-fig but not for the figure. Oh no, everyone liked the gun! So I thought I'd share how to make it real quick. It's very simple and I'm pretty sure a lot of people have these pieces lying around. Take a look! And don't give it a bad rating because it's too simple, because that's how I wanted it to be.
About this creation
Here are the five pieces you will need. A clone head, two angle thingies, a blaster, and a rod.
Start by putting one of the angled pieces in either of the three holes on the bottom side of the blaster. This piece allows you to mount the gun on walls or vehicles and swivel a great amount.
Next, add the other angle part to the two studs located on the side of the blaster. This is just a handle for the gun.
The ammo drum is attached to either stud on the last piece you just installed. Sorry, this pic is really blurry.
Finally, add the barrel to the front of the gun. Voila! It's just that easy!
Feel free to build your own or change and add things to my design. Just remember to give me a little credit if you use this layout. Thanks.
Very nice. I would like to invest in this MG design. I made a little turret for the base in the Clone Trooper battle pack, but it turned out pretty bad. Im going to use this for a new turret
i may use this on the gun for an APC im planning on making for the UPA armed forces. i will give due credit. come check out the new attack jeep as i think you will like it. please leave a review