Quoting Paul Yperman Congratulations with the expo. I was not at home but it would have been more than a pleasure to see the venetor in "life". On the picture he does not even look so large..It supposed to be some two meters or am I mistaking. Would like to keep it as a surprise but I cannot help telling you this : I'm building the instructions for the large venetor on LDD. It's a very large work especially that it is based on the load of pictures you've made and the observation of the captia 5video. I'm watching every detail and with the help of photoshop I can see layers. et des choses que je ne devrais pas voir qui traînent sur le sol. There will be some issues that I'll have to make while building it myself (like the inside structure and the finished underside. Or how the wings are attached to the structure. (I've made the top wings, the republic sign, the complete tower and the tail lower and upper section,rear, turret. Stil to make; the nose, lower wings, bridge,top, engines and the inside structure, sides.. Made on LDD all in smaler items because it would be crazy to make it in one piece. The upper wing alone (in four layers is some 1700pieces (and I used large plates) It is completely the same of what you've build up to one stud. The generated building instructions are absolutely good and even the LDD generated some logic into the build. The HTML file is ok but the moving instructions are better. It is perfectly possible to build it with these instructions. +Some creativity afterwards to put the thing together is needed. If you would have some pictures of the inside structure they would be most usefull. I have the one under the desk, and another one with the sides in technic bricks. If you don't have any more I'll figure it out myself. Many thanks and congratulations.