How to Make a TRON LightCycle: A LEGO® creation by JH Creations . : MOCpages.com

How to Make a TRON LightCycle

Rate it

Add a comment

Zoom in

Welcome to the Grid-uh...MOC.

About this creation

Hey MOCers and People of the Internet. I am back with another How To of How to Make a TRON LightCycle. Full credit goes to George G.'s Design.

You'll need these pieces...

To start, put the U-SHaped piece upside-down.

Take the 2x1 w/ 2 holes and put the flat studs in it. Put that on top of the U piece with studs facing the opposite direction of the U piece's rods.

Stick 2 cheese slopes on either stud.

Add a minifig hand to the rods, along with making a 1x3 plate with a cheese slope on the back.

By now, it should look like this.

Fold the hands back.

Place the tire in between rods, and fold hands back inward and push them back until tire is secure.

Done!

Add your minifig in this position. Mine is a custom TRON fig from the original TRON movie. MOC on that coming later.

Make 2 of these things with a droid arm and minifig hand.

Add them on like so...

Stick your handle inside toe second tire...

Connect it to the minifig hands...

And your DONE!!!

-----------------------------------------------------------------------------------------
Again, full credit goes to George G.'s design. So thats all for now. I will be inactive for 12 days, I am going on vacation again. When I am back I will post more stuff. Until thene, see ya!

Comments