Break Barrel Shotgun (Working): A LEGO® creation by George Staples : MOCpages.com

Break Barrel Shotgun (Working)

Rated 5 out of 5 Change your rating

Zoom in

About this creation

A not so tactical break barrel single shot shotgun. My goal for this gun was to make a shotgun that shot like the real thing. My problem was finding the parts for the shell. So I used.... Garbage cans! They work awesome! You put BB, or little 1x1 round pieces. Then you put the 2x2 dish on top. Also I had to put a 2x2 round plate on the bottom so it would fit on my firing pin.

I made this gun with a pistol grip and stock. The stock is removable. I decided to make a break barrel because I haven't seen a working one. Also the "shells" would be hard to put in a pump shotgun.

The stock is hollow to reduce the weight of the gun.

Also this gun features a hammer to cock the firing pin. The trigger took a while to build, I went through a few ideas till I made this one.

I made it so that you can take the stock off, and just use the pistol grip. There are two gray pins to remove, and two pins on the top to remove, and it comes off.

Thanks for looking!

Building instructions

Download building instructions (LEGO Digital Designer)

Comments

Add a comment

I like it

Mark Martellini

October 19, 2012

Please instructions to mark_mart23@hotmail.com

I like it

John Hall

August 27, 2012

Johnhall14@hotmail.com

I like it

Noah Horst

July 22, 2012

scroom42@gmail.com

I like it

Max The Owl

May 25, 2012

Very creative! I like how your shotgun uses recyclable trash! Normally I don't ask for instructions, but I don't think it will hurt... So if you don't mind, my email address is lucaslegoman@gmail.com (my brother made that one up) :)Good luck!

I like it

jeremy cotto

May 23, 2012

This is awesome. Here is my email address, jeremycotto96@verizon.net