construction journal: how to make a zero out of indies plane: A LEGO® creation by omega (rich) : MOCpages.com

construction journal: how to make a zero out of indies plane

Rate it

Add a comment

Zoom in

finally, after waiting a week for photos to upload, i can finally be done with this page. this was a fun build, though, but i've noticed that mocpages is getting slower, but thats another page.

About this creation

alright, this is indies plane, your $25.00 part of a $50.00 set. its not bad for a plane especially a lego plane.

well obviously the first thing to do is to get rid of the upper wings. don't discard them, because you'll need them later. set them on the edge off your work space.

now, remove the winshield and pieces shown below.......

add a 3x2 brick along that slope and 2 1x2 flats to make a base for the the canopy.

......and you'll end up with this. this is the base for your cockpit.

next remove those pieces to hold up the upper wings, and replace that with a triangle piece. add a white cheese slope and you should get something like this.

now add 2 1x2 flat pieces to the front, and a 3x2 brick on the back.

add a 1x4 brick in front of your 3x2 brick and make the body cannons.

add headlight bricks in the empty forward spaces near the cockpit and put a dot on top of each. put a triangle slope in the back. add your pilot and winshield and your done with the body!!

now drag your wings back out......

and completely dismantle them.

rebuild them with the the front 2 wing pieces equal, and the back 2 wings off set by 1 stud length each. add your 2x6 flats on the underside as support.

take a 1x10 flat and put it from the edge in. put a 2x4 flat next to the body and cover up the 2 spaces missing.

reattach the landing gear, add custom squadron designs on the wings, add on wing guns, and your done!!!

----------------------------------------
4th wall: this was fun. the hardest part was when i dropped it and had to re build it. i know i've got a list on my homepage, but i feel a compliation being posted soon....

Comments