MOCpages : Share your LEGO® creations
LEGO models my own creation MOCpages toys shop Colt .25 Auto V.2: Instructions!Building instructions
Welcome to the world's greatest LEGO fan community!
Explore cool creations, share your own, and have lots of fun together.  ~  It's all free!
Colt .25 Auto V.2: Instructions!
Finally, I can post the instructions for something in just one page! Why? Because the barrel and slide only required a couple of very small changes, while the frame has seen the addition of a new trigger and grip safety. So enjoy, and as always, let me know if the instructions don't meet your needs for world domination. :)
About this creation
Just remember, the profile bricks on the slide are NOT a necessary addition!



Remember that 1 x 3 brick from the barrel on the first version?



You'll have to remove it...







And replace it with this.



The gap left by this piece is there to make room for the new trigger. And there you have the completed barrel!



















Section complete!



















Section complete!







You'll have to build two of these next sections.









Section(s) complete!























Section complete!



















The completed grip safety!



Now, just top it off with an orthodontic rubber band, and it's ready to be added to the frame.











The rubber band runs through the recessed edge of the 1 x 1 stud plate. It's a bit tricky to get it into place. Have you noticed it's also tricky to take photos of?











Note the second orthodontic rubber band in the layout.











The completed trigger! You should probably put the rubber band into place BEFORE you lower the trigger into the frame, but for now, I'll leave it disconnected. I can't hold the trigger in place and take photos at the same time, you know. I'll show you how to connect the rubber band in just a second.







You'll have to lower the trigger into place slightly BEHIND where it snaps in....



Like so!



NOW you can see how the rubber band fits in. The 1 x 1 clip keeps it from getting stuck between the trigger and the side of the frame, and the extra tension makes the trigger pull a little bit heavier. Just top it all off with a 1 x 4 tile...



And you have the completed frame!








THE COMPLETED COLT .25 AUTO V.2!!!!

I doubt if I need to repeat myself, but please don't go waving any LEGO guns around in public! Unless, of course, you'd like to find out how long it takes for the SWAT team to show up. (2 minutes! Uh, I mean...) And as always, please remember where you got these designs if you use them! Enjoy, and thanks for looking!



Comments

 I like it 
  April 29, 2011
No, it only takes 36 seconds... Check your counting! No, kidding, great work!
 
By Nate Andrews
Add to my favorite builders

9
people like this. See who.

7,993 visitors
1 comment
Added April 29, 2011
 You are at the beginning of this folder. Colt .25 instructions part 1: The frame and trigger
More from Nate
More across MOCpages
 You are at the beginning of this group. P3AT Instructions Part 1: The Frame and Trigger
P3AT Instructions Part 2: The Barrel  and Slide  You are at the end of this group.
 


LEGO models my own creation MOCpages toys shop Colt .25 Auto V.2: Instructions!Building instructions


You Your home page | LEGO creations | Favorite builders
Activity Activity | Comments | Creations
Explore Explore | Recent | Groups
MOCpages is an unofficial, fan-created website. LEGO® and the brick configuration are property of The LEGO Group, which does not sponsor, own, or endorse this site.
©2002-2014 Sean Kenney Design Inc | Privacy policy | Terms of use