Now you will have to cut out the inside of the torso.
Take scissors and cut out the inside of the torso.
Use a drill to drill a hole through the neck of the torso.
After drilling and clearing, it should look like this.
Make sure that the battery fits inside before continuing.
drill holes in the head of the minifigure wherever you wish.
This is how the light works. There are two wires that, when touched to the battery, make the light bulb light up.
Check to see if the light bulb fits in the minifigure head.
If it doesn't fit very well, drill a hole through the top.
The leg assembly
Cut sockets in the legs so that the battery can fit all the way.
If it fits inside, it should look like this.
Put the two wires through the hole in the neck, and make sure that they are on either side of the battery. It may take a while to position it just right.
Fit it just like this.
If you did it correctly, it should look like this.
A grim reaper I'm making, completely assembled.
Without the head.
Completed
Light up
I HOPE THIS HAS HELPED YOU. PLEASE COMMENT AND TELL ME IF IT WAS USEFUL. THANKYOU